Several types of bumblebee nest box are available commercially, but we only rarely hear of them being used. We'd like to learn more about how to provide nesting sites for bumblebees. We hope to find out what works, and what doesn't in order to improve designs and guidance - the more people that take part the better. Please help us by trying some of these designs. Register your box with us (via the form at the bottom of this page) to help with our research.

Most species look for a dry, dark, ventilated cavity with a small entrance at ground level. Some prefer an entrance tunnel - 18mm or more in diameter and 30-50cm long. Any old bit of hose or pipe will do, but garden hose is probably too narrow. A pin or nail across the entrance will stop snails from blocking the tunnel, and small drainage holes will prevent water pooling. We've come up with some suggested designs, but be creative and let us know how you get on.  All sorts of designs are possible, using old bricks, stones, or pieces of timber.

Nests should be sited in a sheltered spot along a 'linear feature' (a hedge, bank or fence), out of direct sunlight. Put in a handful of dry moss, upholsterer’s cotton, hair felt or hamster bedding from a pet shop for the bees to mould into a nest. Cotton-wool and fibre-glass insulation should probably be avoided, as the bees may get tangled up in the fine fibres.

Downloadable fact sheets: providing nesting sites or commercial nesting boxes

Design 1
This is the typical 'bumblebee nesting box' and is available from a number of suppliers. Ecotopia sell a wooden design which you could try - they are kindly donating 8% of sales to BBCT

We suspect that these are more likely to work if recessed slightly into a bank so that the hole is at ground level. Better still, attach a 30-50cm length of pipe or tube to the entrance hole (see above). Bury the pipe, and make the entrance an obvious hole in the ground so that the queen can find it easily.

You could try putting in a cradle made of chicken-wire in the nest (for ventilation). Include a large handful of nesting material (see above).

Design 2
You can make this one yourself - all you need is a flowerpot and a bit of tube or pipe more than 18mm in diameter.

Sink an upturned >20cm diameter flower pot into the ground. Put a slate/ tile over the drainage holes to keep out rain. Run a  hose or pipe underground to the pot, leaving a prominent entrance. Be sure to make drainage holes in the pipe.

Again, perhaps make a chicken-wire cradle for ventilation, and fill with a generous handful of nesting material.

Design 3
Some bumblebee species nest above ground, and they occasionally use bird nesting boxes. Unlike birds, they never collect nesting material, so you'll have to put some in the box for them. 

Any bird box would probably do, but you could try these “roosting pockets” sold by Ecotopia and add a 'hat' to keep the rain out. An alternative roofed design is also available - 8% of sales go to BBCT

Hang them somewhere shady and sheltered, perhaps in a hedge, 0.5 - 2m above the ground. Try to reduce the size of the entrance hole, otherwise birds will probably move in!

Design 4
The final design is another one you can easily make. You could even modify your existing patio, and create hundreds of sites!

Simply dig a cavity in the ground (roughly 15cm deep and 25 cm wide) and cover with a paving slab or piece of thick plywood. Dig channels at the sides to provide entrance holes and ventilation (~2cm wide). It should be dry underneath. Try to make the entrance holes as obvious as possible so that the queens can find them.

Again, put a handful of nesting material in the cavity, perhaps in a chicken-wire cradle.